error 502 - too many connections

Get help with all aspects of SABnzbd
Forum rules
Help us help you:
  • Are you using the latest stable version of SABnzbd? Downloads page.
  • Tell us what system you run SABnzbd on.
  • Adhere to the forum rules.
  • Do you experience problems during downloading?
    Check your connection in Status and Interface settings window.
    Use Test Server in Config > Servers.
    We will probably ask you to do a test using only basic settings.
  • Do you experience problems during repair or unpacking?
    Enable +Debug logging in the Status and Interface settings window and share the relevant parts of the log here using [ code ] sections.
Post Reply
User avatar
signal2noise
Newbie
Newbie
Posts: 2
Joined: April 25th, 2010, 2:51 pm

error 502 - too many connections

Post by signal2noise »

I am allowed 20 connections.  I have two servers set up with 10 each, but I keep getting the too many connections error.  What am I missing?
Top
SSelmer
Newbie
Newbie
Posts: 9
Joined: February 28th, 2010, 11:31 am

Re: error 502 - too many connections

Post by SSelmer »

It sometimes takes time to close a connection, and sometimes they are left open until they time out. If you have enough of these over a short time you'll use up your 20 connections. Try lowering your connection-count a bit (7-8) and see if that helps.

Also, if you use 10 connections to the US server-farm and 10 connections to the EU server-farm of the same Usenet provider (at the same time) then you're already using all 20 connections.

Hope that helps.
If I made my forum-avatar a pic of Jake Sully's Na'vi, would that be a meta-meta-avatar?
Top
User avatar
signal2noise
Newbie
Newbie
Posts: 2
Joined: April 25th, 2010, 2:51 pm

Re: error 502 - too many connections

Post by signal2noise »

Thanks.  I've lowered the connections on each to 7 and will see if that helps.  Also, my timeout is set to 120 secs.  Is this a good setting, or is there a better?
Top
Post Reply

Return to “General Help”