SABnzbd Forums

Hi All

Trying to configure HTTPS using port 443.

Whenever I turn SSL on and restart SAB stops downloading and I can't bring up the webapge.

I am using the cert and key that's packaged with SAB and have specified the location on the config page.

Any ideas?

Operating system?

Mac 10.7.3, thanks.

Any port below 1024 requires elevated priviliges.
So you would need to run SABnzbd as a "sudo" job.
This may get you in trouble with access rights of the created files.

That was the problem. Set my port above 1024 and voila.

Cheers, mate.