SABnzbd Forums

Hi all,

Since SABNzbd 0.7.2 I have troubles with repairing corrupted downloads. The repair job won't start and every time I restart SABNzbd there adds another instance of the same movie to the queue. See the screenshot:



I have updated to SAB 0.7.3 today but that didn't fixed the problem.

Do you have any clue about what's going on here?

Thank you very much!
Marcoevich

That's why 0.7.3 was released today.

Hmm, I have 0.7.3 now but I have some troubles with deleting the movie from the queue. I can't delete it and I can't stop the repair job.

Is there a command or something I can give to SAB to completely clear the queue?

Thank you very much!

Marcoevich

I assume you're talking about the stuck job from 0.7.2?
Stop SABnzbd (kill par2 with the task manager if needed).
Go to the admin folder and remove postproc1.sab
Start SABnzbd.
Go to Status->QueueRepair and send the "lost" job(s) back to the queue.

You can see where the admin folder is in Config->Folders (bottom part).

Ok, this worked perfectly

Thanks a lot shypike!