Page 1 of 1

0.7.4 on Ubuntu 10.04 stop responding

Posted: October 20th, 2012, 3:57 pm
by mishou
I keep getting these warnings quite often when sabnzbd became unresponsive
The system load goes at about 4 and restarting the service brings it down to more usable levels

2012-10-20 16:39:30,822 ERROR: [20/Oct/2012:16:39:30] Traceback (most recent call last): File "/usr/share/sabnzbdplus/cherrypy/_cpwsgi.py", line 79, in setapp s, h, b = self.get_response() File "/usr/share/sabnzbdplus/cherrypy/_cpwsgi.py", line 219, in get_response response = self.request.run(meth, path, qs, rproto, headers, rfile) File "/usr/share/sabnzbdplus/cherrypy/_cprequest.py", line 579, in run raise cherrypy.TimeoutError() TimeoutError

Re: 0.7.4 on Ubuntu 10.04 stop responding

Posted: October 20th, 2012, 4:56 pm
by shypike
On what kind of hardware does it run?
Enough memory? A swap partition?

Re: 0.7.4 on Ubuntu 10.04 stop responding

Posted: October 21st, 2012, 2:02 pm
by mishou
It running on a P4 2.4 Ghz with 1Gb of RAM
The box run SAMBA,Apache,Sickbeard,Couchpotato,and transmission
I do see that the memory used is 750Mb and swap used sometimes reach 5% (of the 2.9 Gb partition)

Is the machine underpowered ?

Thanks
Mishou

Re: 0.7.4 on Ubuntu 10.04 stop responding

Posted: October 21st, 2012, 3:23 pm
by shypike
It could be underpowered when running the par2 program.
The name P4 describes a rather wide range, starting in 2000.
Even an Atom runs rings around an early P4, but a late one might be OK.