SABnzbd Forums

I have this problem in 0.7.5 and had it in 0.7.4.
If "Check before download" is enabled and the category/post-processing of a download is changed before the check is finished, this change is lost.
Setting the category when adding the NZB works.
But I often add nzb files by double click instead of adding them in the webinterface (or selecting open when downloading them in the browser).
Then I open the webinterface and change the category. The Problem is now, if I change the category before the check is finished, it reverts back to default after the check.
This is quite often the case, because usually I am at some nzb site, open a few nzbs and then go to sabnzbd to categorize them. Sabnzbd then switches them all back to default before downloading them, but only when all downloads higher up finished.

Here an example:
I set this download to consoles and the check is almost finished:


And whops, suddenly it is default again

Check! I have noticed this as well!!

waryde wrote:I have this problem in 0.7.5 and had it in 0.7.4.

Too bad that you didn't report it sooner.
I'll check what's going on here.

Will be fixed in 0.7.6

shypike wrote:Too bad that you didn't report it sooner.

I did enable this particular feature only very recently and I don't tend to report bugs without proper checking that it is not only based on my stupidity!

shypike wrote:Will be fixed in 0.7.6

Thank you!

0.7.6 Beta1is out, I would appreciate some feedback.

Seems to work now! Thank you!

Thanks, good to hear that this particular issue is gone.