1.0RC1 Add URL Issue

[itsmedoofer]

Hi,

I thought I would give 1.0RC1 a run around the block.

I seem to be having issues with adding a URL though, it would seem any URL I try to add gives a warning of “Empty NZB file”.

If I put the URL into FF I can download the NZB no issues, I can then add the downloaded NZB to SAB with no issues....Also with NZBFOX installed the catcher intercepts it and adds it OK that way...

I’ve tried a couple of NZB sources and browsers, all show the same behaviour.....

In addition if I try to add a NZB using NZBFOX on a supported indexer using the “Sab” button, I get an error “Traceback (most recent call last): File "sabnzbd\urlgrabber.pyo", line 207, in run IOError: [Errno 22] invalid mode”..... I’m worndering if the two are related....

Any ideas ?

Ta,

[safihre]

Try to disable HTTPS validation in Config > Special, turn enable_https_verification to off.

@shypike: same sort of reports on Reddit with failing URLGrabber and invalid-mode:
https://www.reddit.com/r/usenet/comment ... ild_never/
There was another one on Reddit but can't find it right now.

[itsmedoofer]

Hi,

Just tried turning enable_https_verification to off, had no effect though, still got the empty nzb warning...

Edit:-

I saw the Redit post, but thats not me there, it is though what prompted me to register and report

Another Edit:-

URL's with HTTP or HTTPS makes no difference both fail....

Regards,

[itsmedoofer]

Hi,

Any ideas on what could be going wrong, is this particular to my setup, is there anything else I should try ?

Ta,

[safihre]

Could you PM me the link or send it to [email protected] so I can try?

[safihre]

Received the URL's, problem found:
The links does not include the login information or API-key so SAB can't open them.
When I try to open them in my browser I get redirected to both of the indexer's login page.
You need a specific URL with the login information included, or with the API-key included.
When you use these indexers in programs like Sonarr, CouchPotatoe or Sickbeard you would use the API that would also return your API-key in the link for authentication.

Hope that makes it clear!

[itsmedoofer]

Hi,

Thanks, yea my bad looking at it now, sorry guys !

I am still having issue with the URLgrappber crashing when using nzbfoz though, I thought the two could be related but now I guess not....

[itsmedoofer]

All,

The URLGRABBER crash was in part due to nzbfox, Nick C the author is aware and will be releasing a fixed version...

Thanks for all the help guys, really appreciated !