SABnzbd Forums

Hi,

I’ve got an issue with FF3 and FF2 (not with Safari) with plush skin, i’ve cleared my caches of course.

http://dansla.boiboite.net/images/READY ... 195905.jpg

It seems that others osx users have same issue (even with Safari).

You can check comments on http://osx.boiboite.net/2008/06/01/sabn ... /#comments

I've compared interfaces folders between my build and sources and no diffs...

Does anyone got an idea ?

Thanks for the hard work anyway !

Got the same problem with Safari 3.1.1. After deleting the javascript code the problem vanished.

for me too,
thanks a lot pairofdimes,
i'll update the osx build as soon as possilble

It works fine now with FF3 and IE7 on XP

I noticed another minor issue:
in Plush there is an extra forward slash in the configuration/servers screen,
behind the 120 timeout value.

Still in the SVN trunk. Just thought to let you know.

Regards, Bryan Wats

pair of dimes wrote: Added in a new AJAX max speed adjuster, if someone could test this from the svn trunk that'd be stellar

Tested last night, does not work: still full speed dl (why wouldn't you, but that's a different question).
Also, be sure the refresh rate is not set too high, otherwise it is impossible to enter value.

Regards,
Bryan Wats

pair of dimes wrote:

bpwats wrote: Tested last night, does not work: still full speed dl (why wouldn't you, but that's a different question).

switch fixed this this morning so it will work.

confirmed working: the dl speed hovers aroud the set value

bpwats wrote: Also, be sure the refresh rate is not set too high, otherwise it is impossible to enter value.

You mean if you have a 1 second refresh it won't let you type anything in? That may have been fixed along with the above issue.

Correct, it is near impossible. It keeps refreshing to the set value. When selected, it should not update until enter/deselected.
Now one is forces to reduce refresh updates, to allow enough time to change value between refreshes.

Thank you,
Bryan Wats

pair of dimes wrote:

bpwats wrote: Also, be sure the refresh rate is not set too high, otherwise it is impossible to enter value.

This is now fixed.

Confirmed.

B. Wats